head	1.2;
access;
symbols;
locks; strict;
comment	@# @;


1.2
date	2012.11.17.01.52.48;	author svnexp;	state Exp;
branches;
next	1.1;

1.1
date	2012.08.29.01.08.36;	author adrian;	state Exp;
branches;
next	;


desc
@@


1.2
log
@Switching exporter and resync
@
text
@#
# Specific board setup for the Atheros AP91 reference board.
#
# The AP91 has the following hardware:
#
# + AR7241 CPU SoC
# + AR9287 Wifi
# + Integrated switch (XXX speed?)
# + 4MB flash
# + 16MB RAM
# + uboot environment

# $FreeBSD: head/sys/mips/conf/AP91 239799 2012-08-29 01:08:36Z adrian $

include		"AR724X_BASE"
ident		"AP91"
hints		"AP91.hints"

options		AR71XX_REALMEM=16*1024*1024

options		AR71XX_ENV_UBOOT

# Limit inlines
makeoptions	INLINE_LIMIT=768

# We bite the performance overhead for now; the kernel won't
# fit if the mutexes are inlined.
options 	MUTEX_NOINLINE
options 	RWLOCK_NOINLINE
options 	SX_NOINLINE

# There's no need to enable swapping on this platform.
options 	NO_SWAPPING

# For DOS - enable if required
# options 	MSDOSFS

# uncompress - to boot read-only lzma natively from flash
device		geom_uncompress
options		GEOM_UNCOMPRESS
options		ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"

# Not enough space for these..
nooptions 	INVARIANTS
nooptions 	INVARIANT_SUPPORT
nooptions 	WITNESS
nooptions 	WITNESS_SKIPSPIN
nooptions 	DEBUG_REDZONE
nooptions 	DEBUG_MEMGUARD

# Used for the static uboot partition map
device          geom_map

# Options needed for the EEPROM based calibration/PCI configuration data.
options 	AR71XX_ATH_EEPROM	# Fetch EEPROM/PCI config from flash
options 	ATH_EEPROM_FIRMWARE	# Use EEPROM from flash
device		firmware		# Used by the above

# Options required for miiproxy and mdiobus
options 	ARGE_MDIO		# Export an MDIO bus separate from arge
device		miiproxy		# MDIO bus <-> MII PHY rendezvous

device		etherswitch
device		arswitch
@


1.1
log
@SVN rev 239799 on 2012-08-29 01:08:36Z by adrian

Bring over a configuration for the Atheros AP91 reference board.

This has an AR7240 SoC with an AR9285 wireless NIC on-board.

Since the kernel partition on the 4MiB flash is 960KiB, quite a bit
is disabled to try and squeeze the build into that.  Even lzma'ed,
it's still quite large.
@
text
@d13 1
a13 1
# $FreeBSD$
@

